Standard Wireless Router Mode - TP-Link TL-WR810N User Manual

host(s) to access AP. You can configure your device quickly by the following steps in different
modes.

3.2.1 Standard Wireless Router Mode

When you set the operation mode switch to Router/AP, take the following steps:
1. Select Standard Wireless Router mode and click Next.
2. WAN Connection Type page will appear as shown in
The Router provides Auto-Detect function and supports five popular ways Dynamic IP, Static IP,
PPPoE/Russia PPPoE, L2TP/Russia L2TP and PPTP/Russia PPTP to connect to the Internet.
If you are sure of what kind of connection type your ISP provides, you can select the very type and
click Next to go on configuring. If you are not sure of what kind of connection type your ISP
provides, you can select Auto-Detect and click Next to go on configuring.

Note:
Auto-Detect function is not suitable for L2TP/Russia L2TP and PPTP/Russia PPTP, you need to
specify the connection type manually.
If you select Auto-Detect, the Router will automatically detect the connection type your ISP
provides. Make sure the cable is securely plugged into the WAN port before detection. The
appropriate configuration page will be displayed when an active Internet service is successfully
detected by the Router. Then follow the instructions to complete the configuration.
1) If you select Dynamic IP manually, the next screen will appear as shown in Figure 3-6.

In most cases you don't need to clone the MAC address if you have rebooted the
modem with the new router, please select No, I do NOT need to clone MAC
address.

If you can't get the Internet connection after Quick Setup, please run it again and
select YES, I need to clone MAC address.
Then click Next and Figure 3-11 will appear.
TL-WR810N 300Mbps WiFi Pocket Router/AP/TV Adapter/Repeater
Figure 3-5 Quick Setup - WAN Connection Type
Figure 3-5
- 13 -
.