TP-Link TL-WR810N User Manual page 32

Wireless Network Name - Enter a string of up to 32 characters. The same name of

SSID (Service Set Identification) must be assigned to all wireless devices in your
network. The default SSID is set to be TP-LINK_XXXX (XXXX indicates the last unique
four numbers of each Router's MAC address). But it is recommended strongly that you
change your networks name (SSID) to a different value. This value is case-sensitive.
For example, TEST is NOT the same as test.
 Region - Select your region from the pull-down list. This field specifies the region where
the wireless function of the Router can be used. It may be illegal to use the wireless
function of the Router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
Channel - This field determines which operating frequency will be used. The default

channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
 Wireless Security Mode - This option should be chosen according to the security
configuration of the AP you want to access. It is recommended that the security type is
the same as your AP's security type.
Wireless Password - Input the password of your broadcast SSID.

3. Click the Next button. You will see the Network Setting page as shown in Figure 3-14. You
can configure the IP parameters of LAN on this page.
TL-WR810N 300Mbps WiFi Pocket Router/AP/TV Adapter/Repeater
Figure 3-13 Quick Setup - Wireless Setting
- 18 -