Speaker - AT&T definity 7444 User Manual

Speaker

Note: Your telephone is set for either the Speaker (listen-only) or the Speakerphone
(listen and talk) function. Check with your System Manager to see which of these two
features you can use. You can use the Reset Speakerphone feature only if your
telephone is set for Speakerphone (listen and talk).
Use the following procedures if your telephone is set for the Speaker (listen only)
feature.
To place a call without
lifting the handset, or
to use speaker with
any listening-only
activity (such as,
monitoring a call on
which you have been
put on hold or for
retrieving messages)
Note: In order for the
other party to hear
you, you must speak
through the handset.
Note: If your telephone is set for the Speaker feature, the Mute feature is activated
and the light next to  Mute 
Pressing  Mute  while you are on a call using the handset affects only the microphone
associated with the handset.
To mute the
microphone associated
with the handset so the
other party cannot hear
you
To activate the speaker
while using the handset
1
Press  Speaker-Reset Spkr 
2 Place call or access selected feature
3
Adjust speaker volume if necessary
To raise the volume, press the right half of the
Volume control button labeled [
volume, press the left half of the Volume control
button labeled [
Display shows [ SPEAKER L >>>> H ] (There are 8
possible volume settings. On the display, 1 arrow is
the lowest setting and 8 arrows is the highest setting)
goes on whenever you use the speaker.
1 Press  Mute 
Red light goes on and other party cannot hear you
2 Press
 Mute  again to resume talking to other party
through handset
Red light goes off and other party can hear you again
1 Press
 Speaker-Reset Spkr 
Green light next to
 Mute  go on steadily
The speaker is active, and the handset is turned off
]; to lower the
]
 Speaker 
and the red light next to
[ _ ]
28