Select Button
To use any of the
features that require
the Select button
( -Select )
Select Ring (and Ringer Volume)
To select a personalized
ring
1 Choose any of the following after pressing
Press
Drop-Test
to initiate a self-test of your telephone
lights, ringer, and display. For procedures, see "Self-
Test" in this section.
Press
Conference-Ring
patterns for your telephone. For procedures, refer to
"Select Ring" in this section.
Speaker-Reset Spkr
Press
quality of your built-in speakerphone. Use whenever
you move your telephone to a different location (even
in the same room), when the telephone is unpluggd,
or when there has been a power failure. For
procedures, refer to "Speakerphone" in this section.
1
While on-hook, press
Green light goes on steadily
Press
Conference-Ring
2
Green light next to
pattern plays and repeats every 4 seconds
Display shows [ PERSONAL RING #x ] (x will be a
number from 1 to 8)
Conference-Ring
Continue to press
3
ringing patterns
When you hear the desired ringing pattern, press
4
-Select
again
Your new ring is set; green light next to
off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
start again. If you lose power after you have selected
your personalized ring you will have to select your
ring pattern again.
-Select :
to select one of 8 personalized ringing
to adjust the sound level and
-Select
-Select
flutters; current ringing
to cycle through all 8
-Select
[ ]
[ ]
goes
25