Replacing The Power And Volume-Buttons Board; Procedure; Post-Requisites - Dell 13 7000 series Service Manual

Replacing the power and
volume-buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Place the power and volume-buttons board in the slot on the palmrest
and keyboard assembly and snap the tabs into place.
2 Adhere the tape that secures the power and volume-buttons board to the
palmrest and keyboard assembly.
3 Using the alignment post, place the left speaker on the palmrest and
keyboard assembly and snap it into place.
4 Route the power and volume-buttons board cable through the routing
guides on the speaker.
5 Connect the power and volume-buttons board cable to the I/O board.
6 Adhere the tapes that secure the power and volume-buttons board cable
to the palmrest and keyboard assembly.

Post-requisites

1 Follow the procedure from step 4 to step 6 in
2 Replace the battery.
3 Replace the base
38
computer. After working inside your
cover.
After working inside your
"Replacing the hard drive".