Check Seams And Overlaps For Good Seal - AeroWorks 50cc EXTRA 300 ARF-QB Assembly Manual

CHECKING SEAMS AND COLOR OVERLAPS FOR GOOD SEAL
1. Go over all seams and color overlaps with your
sealing iron.
Note: Even if your models covering has no wrin-
kles out of the box it is still very important to go
over all seams and overlaps to make certain they are
sealed securely. This is especially important at the
leading edges of the wings and stabs. We recom-
mend checking the covering after each flying ses-
sion.
2. Use your covering iron to ensure all edges,
seams, and color overlaps are securely sealed.
This is an optional step but is recommended
3.
Cut strips of clear covering to fit the hinge
gaps. Use covering iron to seal the clear
covering snugly into the bottom of the
hinge lines as shown for air tight hinge
seals.
Note: Remove clear pro-
tective backing
from film.
IMPORTANT:
It is the responsibility of the purchaser /
operator to check the covering seams and
overlaps for security and a good seal.
Aeroworks is not responsible for failure of
covering seams or overlaps during flight.
Note: If covering continues to lift apply a small
amount of thin CA underneath the covering.
Then using a clean rag apply pressure to secure.
One of the most important tools in your
flight box is a roll of clear tape. This can be
used at the field for fast and easy repairs of
the covering. Then once you have finished
flying the covering can be permanently
repaired.
11
.