Table of Contents
Advertisement
CHECKING SEAMS AND COLOR OVERLAPS FOR GOOD SEAL
1. Go over all seams and color overlaps with your
sealing iron.
Note: Even if your models covering has no wrin-
kles out of the box it is still very important to go
over all seams and overlaps to make certain they are
sealed securely. This is especially important at the
leading edges of the wings and stabs. We recom-
mend checking the covering after each flying ses-
sion.
2. Use your covering iron to ensure all edges,
seams, and color overlaps are securely sealed.
Use a small trim iron to iron out the wrin-
3.
kles in the hinge lines. It is important to
keep the covering sealed down in this area.
Note: Take care not to apply to much heat
around any plastic or corrugated parts.
IMPORTANT:
It is the responsibility of the purchaser /
operator to check the covering seams and
overlaps for security and a good seal.
Aeroworks is not responsible for failure of
covering seams or overlaps during flight.
Note: If covering continues to lift apply a small
amount of thin CA underneath the covering.
Then using a clean rag apply pressure to secure.
One of the most important tools in your
flight box is a roll of clear tape. This can be
used at the field for fast and easy repairs of
the covering. Then once you have finished
flying the covering can be permanently
repaired.
12
Advertisement
Table of Contents
