Victoria Arduino ADONIS 3 gruoups Manual page 53


NOTE
The machine is not operative in that the main switch
only supplies the electronic card.

WARNING
For electronic card maintenance, turn the machine off
by means of the external main switch or disconnect the
plug.
MANUAL SwITCHING ON / OFF
Automatic On / Off NOT PROGRAMMED
SwITCH ON
press the RESET key for 2 seconds, the buzzer will beep,
the display will light up to indicate the release of the
EPROM for about 1 second.
The control unit will start up an auto diagnosis cycle
to check the functions, all the selection keys will light
up.Once the check is completed the display will read:
HEATING
with the day and time. When 110°C has been reached,
the heating message will disappear and will be replaced
by the words:
MACHINE READY

NOTE
On completion of the check up all the selection keys
are activated.

WARNING
In case the auto diagnosis indicates error or malfunc-
tion, call an assistance centre; the operator MUST NOT
intervene.
POwER OFF
press the RESET key for 2 seconds; the machine will turn
off and the display will read:
OFF
Automatic On / Off PROGRAMMED
The machine will SWITCH ON at the first programmed
switch-on time (see the section entitled PROGRAMMING
at the paragraph PROGRAMMING ON - OFF).
The control unit will perform an auto diagnosis of all func-
tions and all of the selection keys will light up.
Once the diagnosis is complete, the display will read as
follows:
HEATING
51 51