Operating Tips - Electra DCR 25 Service Manual

OPERATING TIPS

Set a suitable room temperature; excessively low room temperature is not good for
your health and wastes electricity. Avoid frequent setting of the temperature.
During cooling, avoid direct sun. Keep curtains and blinds closed. Close doors and
windows to keep the cool air in the room.
Avoid generating heat or using of heating appliances while the air conditioner in
cooling mode.
Make sure that the air flap is positioned properly: horizontal flow in cooling and
downward vertical flow for heating.
Keep the room temperature uniform by adjusting the left/right vertical air blades.
Position the air flap and the left/right air blades in such a manner as to prevent your
body from being exposed directly to air drafts.
During prolonged operation, ventilate the room occasionally by opening a window from
time to time.
In a power failure, the microprocessor memory is retained. When restarted, operation
will be resumed in the last mode of operation. However, if the timer was used, the unit
will be turned off by the timer only if the remote control is aimed at the unit. Otherwise
the power failure will cause the timer data to be erased from the microprocessor
memory.
After turning on, allow more than 3 minutes for cooling, heating or dry operation to
start.
When COOL or DRY modes are used, make sure that the room's relative humidity is
below 78% If the unit is used for a prolonged periods of time in high humidity, moisture
may form on the air outlet and drip down.
Remote control signals may not be received if the indoor unit controls cover is
exposed to direct sunlight or strong light. In such a case, block the sunlight or dim the
lighting.
The remote control is operative in a range of 8 meters. If you are out of range, the
remote control may have difficulties in transmitting signals.
8
CONTENT APPENDIX A