Electra DCR 25 Service Manual page 61

AUTO FLAP
VERTICAL
AIR SWING
HORIZONTAL
AIR SWING
FILTER
INDICATION
ROOM
TEMPERATURE
BUZZER
ON UNIT
OPERATION
3-MIN
DELAYED RUN
MEMORY
LOCK
4
The air flap (louver) is automatically positioned for the most suitable blow-out
angle, when COOL, HEAT, DRY or FAN modes are selected. When the air
conditioner is turned off, the flap will close automatically for an aesthetic
appearance.
Automatic swing of supply air in vertical direction. The flap moves
automatically in upward and downward direction to spread the conditioned
air evenly throughout the room.
Manual positioning of the air flap to provide desirable air flow angle.
Filter indicator on the indoor unit display is turned on when the filter requires
cleaning. After cleaning and reinstalling the filter, It should be reset.
Measures and displays room temperature.
A soft buzzer will sound from the indoor unit display to indicate that a
command sent by the remote control has been accepted and stored in the
unit's memory.
The air conditioner can be turned ON for COOLING or HEATING or be
turned OFF directly from the indoor unit display panel without the use of the
remote control.
The compressor is protected by a three-minute delayed restart.
The microprocessor retains the last data entry whether or not the unit is
plugged in. Therefore, when the unit restarts after a power disruption or
failure, it will resume operating in the same mode as before the power was
disrupted.
Freezes the last operation setting on the remote control. When LOCK is
activated, the remote control will not be able to control the air-conditioner.
CONTENT APPENDIX A