Advertisement
Available languages
Available languages
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch the tool on
and off.
Before starting your work, check the proper function by
pressing the TEST button.
Use only extension cable with sufficient cross-section (min. 2,5 mm
cross-section which is to small could lead to excessive power loss and to
overheating the motor and the cable.
Recommended minimum cross sections and maximum cable lengths
Mains
voltage
110V
230V
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Additional Handle
For manual drilling, the ETN 130/3 P may be used only
together with its additional handle which comes with the
tools. Place it on the gearing collar from the front and fix it by
turning the handle in direction of the arrow.
Water Supply
The connector for the tool should be a GARDENA hose connector.
Cross section in sq. mm
1.5
20 m
50 m
Place the adapter with the ball valve onto the tool's
connector and turn into the direction of the arrow up to
the stop. Connect the tool to the water supply system or
a water pressure vessel using the push fit nipple.
Attention! The maximum water pressure should not
exceed 6 bars. In case of higher water pressure, a
pressure relieve valve must be used.
23
2
). A
2.5
40 m
80 m
Advertisement
