Advertisement
Available languages
Available languages
Unplug the tool if it stops for any reason. So you avoid sudden starts in
unattended condition.
Don't use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
Always lead the mains and extension cables as well as the dedusting
hose from the tool to the back.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
On using the tool, in no case cooling water may seep into the motor or
the electric components.
If water comes out of the drainage hole at the gear neck, stop your
work and have the tool repaired by an authorised service centre.
Perform overhead drilling only with suitable protective appliances
(water catcher).
After interruption of your work, restart the tool only after having made
sure that the drill bit is moving freely.
The tool may be used only in two-hand operation or with the drill rig.
Keep the handles dry, clean, and free of oil and grease.
Do not touch rotating parts.
Persons under 16 years are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable goggles, helmets, ear protectors, dust mask, protective cloves
and boots.
During manual operation, always hold the tool with both hands
and be fall-safe. Consider the tool's reaction torque in case of
blocking.
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
During manual operation, work with a special circumspection
when dry drilling with dimensions between 100 and 200 mm !
For further safety instructions, see the enclosure.
The ETN 130/3 P is made in protection class I. For protection purposes the
machine can only be run with a GFCI. The machine is standard equipped
with a PRCD switch in the cord which allows to connect the unit direct to a
socket.
Electrical Connection
22
Advertisement
