Maintenance; Replacement Of Fuses - Hensel Integra 250 Plus User Manual

User manual // Integra Plus // Compact flash unit

10 Maintenance

9
48
The Integra Plus compact flash series is in need of little
maintenance by the user. The unit should be dry cleaned
from dust from time to time. Before cleaning separate the
unit from the mains outlet.
Caution: Under no circumstances is any part of the
equipment to be opened. The equipment is not user-
serviceable and there is dangerous high voltage. In
the event of difficulty notify your dealer.

Replacement of fuses

In case of a broken fuse 9 replace fuse only when the unit
is switched off and separated from the mains outlet.
Attention:
Never repair or bridge fuses. Only use "fast" fuses
with the required value:
Fuse for operation with modeling light
300W / G6.35halogen
4 AF (5x20 mm)
Only use fuses in accordance with EN 60127-2/1 or
respectively IEC 127-2/1. A wrong fuse may cause a
bursting of the halogen modeling lamp.
Replacement of modeling lamp
Attention: Turn the unit off and disconnect it from any
power supply before replacing the modeling light.
Wait at least 15 minutes before continuing the
procedure and until the halogen lamp has cooled off.
Depending on the mains circuit, only the specified
modeling lamps should be used (see below). When
changing the modeling lamp, please note that it will
be secured by the correct value.
Use only halogen lamps as modeling light with the
maximal light output specified as follows:
300W / G6.35 / 115V (Code 1280)
or
300W / G6.35 / 230V (Code 128), resp.
HENSEL-VISIT GmbH & Co. KG