Accessories - Hensel Integra 250 Plus User Manual

User manual // Integra Plus // Compact flash unit
The glass dome is fixed by means of the three pre-
mounted springs. For doing this, please tilt the glass
dome slightly and insert it into one of the three springs.
Then press the glass dome gently into the other two
springs until it has completely clicked in. For removing the
glass dome, please tilt it slightly again so that it will slip
out easily of the two fixing springs. Then gently loose the
glass dome from the remaining third spring and remove it
from the fixing device.

Accessories

All Hensel reflectors and Hensel softboxes of series EH
(adapter Ø: 10 cm), accessories included, may be
attached to the Integra Plus compact flash; also umbrellas
and Softstars.
Assembly of reflectors and softboxes
For fixing reflectors or softboxes to the compact flash unit,
please first of all open the holding clamps. For doing this,
please tension the reflector lever laterally as far as it will
go against the spring tension. While doing this, the
holding clamps will open. Now attach the accessory part
even and precisely to the unit. Please do not tilt. By
releasing the lever, the holding clamps will enclose the
accessory part completely.
For loosening the accessory, please hold tight the
accessory part (Attention - it could be hot!) and tension
the lever again as described above.
In any case please make sure not to damage either the
flash tube or the modeling lamp (danger!).
Assembly of umbrellas and Softstar
An umbrella holder is integrated in the tilting head that
allows for the connections of various umbrellas by using a
strong gripping spring mechanism. The umbrella is
inserted into the hole above the fixing bracket 20 and
20, 18
fastened by tightening the clamping screw 18.
39
HENSEL-VISIT GmbH & Co. KG