Mains Connection; Fuses; Overheating - Hensel Integra 250 Plus User Manual

User manual // Integra Plus // Compact flash unit
10, 15
10 A
9:
4 AF
14:
<E1>
40

Mains connection

Attention:
Before connecting the compact flash unit to the mains
outlet, make sure that the mains voltage matches the
information given on the type label of the compact flash.
The type label can be found on the bottom of the
appliance. The Integra Plus series comes with bi-voltage
technology, i.e. the compact flash adjusts itself for
different main voltages. (110 V and 230 V)
The provided power cable has to be led through the
handle, then attached to the mains socket 10 and
connected to the mains outlet. Use the cable fixation 15
for allowing unhindered tilting of the unit.
Compact flashes must only be connected to mains
outlets with ground connection.

Fuses

Outlets in the building
Minimum requirement 10 A fuse outlets
Fuses of the compact flash unit
The fuse 9 is a general fuse for the compact flash unit and
the modeling lamp. All units of the Integra Plus series (bi-
voltage technology) come with a fuse 4 A fast (4 AF, 5x20
mm).
The specification of the fuses mentioned above is valid for
operation with modeling light 300 W halogen.
For more information, please refer to page 48-49,
Replacement of fuses.

Overheating

All Integra Plus units are equipped with a fan to avoid
overheating with fast flash sequences, which could cause
damage to the flash tube and the compact flash unit.
Nevertheless, if overheating occurs, the error <E1> is
displayed on the LED 14. After a break for cooling down,
the appliance is ready again for operation.
HENSEL-VISIT GmbH & Co. KG