Radio Control Unit; Strobe Wizard Plus - Hensel Integra 250 Plus User Manual

User manual // Integra Plus // Compact flash unit
13
3:
AUDIO

Strobe Wizard Plus

transmitter
(Code no. 3950)
2:
RC
13
14
44
Reset of the flash counter is done by pressing the flash
power control switch 13. The menu can be left by re-
peated press of the AUDIO button 3. After 5 sec. the
menu closes automatically.
9 Radio Control System
Strobe Wizard Plus
The transmitter of the Hensel radio flash trigger and
power control system Strobe Wizard Plus is used for
triggering flashes, adjusting the flash power and switching
the modeling lamp between FULL/OFF/ PROP in Hensel
flash units with built-in receiver via radio signal.
Every use of the equipment that differs from its prescribed
use is prohibited. In particular, controlling of electronical
items or machines other than described above is
prohibited.
Scope of delivery
The radio transmitters (Code No. 3950 or 3955) come
with a synchronization cable with 2,5 mm synchronization
plug.
Safety instructions
Changing this unit is strictly prohibited. The housing is
splash-proof but not watertight. Therefore protect the
equipment from humidity. The operation during rain is not
recommended because over the years moisture might
ingress into the housing causing damage to the
electronics.
Start-up and channel selection – built-in receiver –
By pressing the RC button 2 the built-in receiver of the
Integra Plus units is switched on. The channel can be
selected by pressing the flash control switch 13 once. By
turning the knob, channels from 1 to 3 can be selected as
shown on the LED display 14. After 3 seconds delay or by
pressing switch 13 again the channel is set and the dis-
play changes to the flash power setting.
HENSEL-VISIT GmbH & Co. KG