Regency Plateau PTO30-NG1 Owners & Installation Manual

Hide thumbs Also See for Plateau PTO30-NG1:

Advertisement

Regency Plateau
Decorative Gas Appliance
www.regency-fire.com
WARNING:
If the information in these instructions
are not followed exactly, a fire
or explosion may result causing
property damage, personal injury or
loss of life.
WARNING:
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property damage.
Read the installation, operating and
maintenance instructions thoroughly
before installing or servicing this
equipment.
Installation and service must be
performed by a authorised installer,
service agency or the gas supplier,
in accordance with this manual
FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4
919-164c
PTO30 Outdoor
®
What to do if you smell gas:
•Shut off gas to the appliance.
•Do not try to light any appliance.
•Extinguish any open flame.
•If odour continues, keep away from the appliance and im-
•Do not touch any electrical switch: do not use any phone
•Immediately call your gas supplier from a neighbour's
•Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire
Do not store or use gasoline or other flammable vapours
and liquids in the vicinity of this or any other appliance.
Installer: Please complete the details on the back cover
and leave this manual with the homeowner.
Homeowner: Please keep these instructions for future reference.
WARNING: FOR OUTDOOR USE ONLY
WARNING - FOR YOUR SAFETY
mediately call your gas supplier or fire department.
in your building.
phone.
department.
WARNING:
Owners &
Installation Manual
Models: PTO30-NG1 / PTO30-LPG1
PTO30-ULPG1
LISTINGS AND CODE APPROVALS
These gas appliances have been tested
in accordance with AS4565 / AS4558
and have been certified by the IAMPO
Oceana for installation and operation
as described in these Installation and
Operating Instructions.
Your unit should be serviced annually
by an authorised service person.
04.09.15

Advertisement

Table of Contents
loading

Summary of Contents for Regency Plateau PTO30-NG1

  • Page 1 Owners & Regency Plateau PTO30 Outdoor ® Installation Manual Decorative Gas Appliance Models: PTO30-NG1 / PTO30-LPG1 PTO30-ULPG1 LISTINGS AND CODE APPROVALS These gas appliances have been tested in accordance with AS4565 / AS4558 and have been certified by the IAMPO...
  • Page 2 To the New Owner: Congratulations! You are the owner of a state-of-the-art Outdoor Decorative Gas Appliance by REGENCY . The ® Plateau PTO30 Outdoor decorative gas appliance has been designed to provide you with all the ® charm of a fire at the flick of a switch. The Plateau PTO30 Outdoor Decorative Gas Appliance ®...
  • Page 3: Table Of Contents

    Lighting Procedure ............24 Shutdown Procedure ...........24 First Fire ..............24 Indoor storage of cylinders ..........24 Identification for leaks ..........24 Copy of Lighting Plate Instructions ......25 Maintenance Instructions..........26 Valve assembly replacement ........27 Parts ................28 Limited Warranty: ............30 Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 4 TO BE INSTALLED BY AN AUTHORISED PERSON Primarily a decorative appliance - not certified as a space heater. THIS APPLIANCE SHALL NOT BE INSTALLED OR USED INDOORS Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 5: Pto30 Finished Table Top And Unit Dimensions

    DIMENSIONS PTO30 FINISHED TABLE TOP AND UNIT DIMENSIONS 37-9/16" (953mm) TOP VIEW 33-1/4" (844mm) 8-1/4" (210mm) 36-7/16" (932mm) SIDE VIEW END VIEW Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 6: Important Message

    California to cause cancer, birth defects or 3) Inspect the burner before each use of the other reproductive harm. USED IN A BUILDING, GARAGE OR ANY appliance for blockage and any signs of deterioration OTHER ENCLOSED AREA. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 7: Installation Checklist

    PIPING SYSTEM, OR A PERMANENTLY CON- the total wall area shall be and remain NECTED PIPING SYSTEM TO A REMOTE LPG open and unrestricted. SUPPLY TANK Open side at least 25% of total wall area Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 8: Minimum Clearances To Combustibles

    ENSURE MINIMUM HEIGHT IS 750MM TO TOP OF GLASS SURROUND. IF INSTALLED LOWER THAN 750MM WITH GLASS SURROUND, INSTALLER MUST PROVIDE A MEANS OF SECONDARY GUARD, NOT ATTACHED TO, BUT SURROUNDING THE PTO30 BURNER WITH A MINIMUM HEIGHT OF 750MM. Alcove Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 9: Inner Framing Dimensions (Required)

    SIDE VIEW END VIEW NOTE: PTO30 - Two (2) ventilation grills are required for all enclosures. This is to alleviate moisture and allow for air to circulate. Minimum recommended size 20" sq (508 mm²) ea. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 10: Conversion From Ng To Lpg/Ulpg

    4) Slide burner away from burner orifi ce and lift up to remove burner assembly. 7) Re-install pilot cap. 8) Adjust aeration accordingly.- see manual for details. Burner orifi ce Pilot Cap Regency Plateau™ PTO30 Outdoor Gas Fireplace 919-127 06/06/12...
  • Page 11 13) Check all gas connections under normal operating pressure, for leaks, with soapy water. NOTE: If soap bubbles, this would indicate a gas leak. 14) Check inlet and outlet pressures. 15) Check operation of fl ame control. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 12: Finishing

    Determine the thickness of the finishing material before adjusting the nailing strips. 1/2" 2-3/8" 1/8" Increments 1/4" Increments OPTIONAL FINISHING TRIM Optional finishing trim is supplied with the PTO30 - place finishing trim on unit between unit and finishing material. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 13: High Elevation

    Inspect hoses before each use and replace if gas valve, disconnect the hose and tighten the evidence of excessive abrasion. screw (clockwise) with a 1/8" flat screwdriver. Note: Screw should be snug, but do not over tighten. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 14: Pto30 Wall Switch Installation

    4) Route low voltage wire and battery extension wire through the strain relief. 5) Connect low voltage wire to supplied switch, fasten switch to right side of electrical box (polarity not important). 08/15/11 919-070 Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 15: Pto30 Drain Installation (Recommended)

    Cut notches into the top of the coupling reducer to prevent water pooling. Threaded Elbow Threaded @ 90° Reducer (PVC) (PVC) View from under- side of unit. Reducer and elbow can be purchased from your local hardware store. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 16: Pto30 Wiring Diagram

    Standard Main On/Off Switch or Optional Wall Switch The appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with the National Electrical Code, ANSI/NFPA 70, if applicable. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 17: Table Cover Installation

    End Cap INSTALLATION Final Install TABLE COVER INSTALLATION TABLE COVER INSTALLATIONS DINING LEAF For all units: 1) Place the dining leaf cover over the burner of the unit when not in use. 919-056 08/15/11 Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 18: Glass Crystal / Basalt Volcanic Stones Installation

    The Burner should not be visible when the flame is out. NOTE: Basalt Volcanic Stones are NOT to be placed anywhere on the Pilot assembly area. Glass Crystals to be installed on the burner prior to installing stones. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 19: Glass Surround Installation

    Repeat process on other end. Press down firmly from to secure glass surround/windshield in position. Use care not to scratch surfaces. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 20 NOTE: IF THE BURNER HAS BEEN CONVERTED TO LPG, THE CYLINDER CANNOT BE INSTALLED WITHIN THE FRAMING KIT, AND MUST BE CONNECTED VIA A PERMANENT PIPING SYSTEM TO A REMOTE LPG SUPPLY TANK 10/24/12 919-167a Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 21 Diagram 6 - Outside Part B Part A Diagram 3 3. Attach inside tall vertical supports (Part B) to short vertical supports (Part C) with one (1) screw each. Part B Part C Diagram 4 919-167a 10/24/12 Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 22 Diagram 1 - Bend tabs to 90º for each support. 2. Position panel - lower tabs line up with indents in base. Diagram 2 - Lower tabs on panel aligned with base Diagram 12 - Part F locations Regency Plateau™ PTO30 Outdoor Gas Fireplace 10/24/12 919-167a...
  • Page 23 Flattened Tabs Diagram 3 - Bend tabs at, panels is supported on headers. 4. Install top panel with six (6) screws in locations shown below. Diagram 2 - Top Panel screw locations 919-167a 10/24/12 Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 24: Operating Instructions

    5) Check all connection, fitting, hoses prior to each use. PROCEDURE 1) Turn ON/OFF switch. 2) If service is to be performed - you must discon- nect power to the unit, by removing the battery pack. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 25: Copy Of Lighting Plate Instructions

    THIS INSTRUCTION PLATE c) L'unité répétera l'étape 2. c) Unit will repeat step 2. appliance. Jan 19/10: Created draft for approval 918-892a Feb 16/10: Changed size of decal xcept er than cut clearance. r approval decal Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 26: Maintenance Instructions

    Use an ammonia based cleaner (ie. glass cleaner) to remove this film before applying heat to the unit. Failure to do this will result in burn stains on panels which you will be unable to remove. 5) The heater is finished in a heat resistant paint and should only be refinished with heat resistant paint. Regency ®...
  • Page 27: Valve Assembly Replacement

    13) Rotate HI/LO modulationg valve all the way to the left for HI position. 8) Remove green EV2 wire connected to the gas valve. 14) Install new valve assembly and reverse steps 11-1. 15) Test gas connections for leaks. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 28: Parts

    Mounting Bracket 377-046 Controls Enclosure 377-034 Pilot Shield 377-510 Valve Tray 377-027 Burner Mount 377-047 Components Cover 377-028 Burner Tray End 377-048 Pilot Shield support 377-030 Offset Bracket 377-054 Drainage Bracket 376-512 Electronic Assembly Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 29 NOTES Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 30: Limited Warranty

    ® Regency shall in no event be liable for any special, indirect consequential damages of any nature whatsoever which are in excess of the original purchase price of the product. Any alteration to the unit which causes sooting or carboning that results in damage to the exterior facia is not the responsibility of Regency Fireplace Products.
  • Page 31 NOTE: PLEASE RETAIN YOUR INVOICE AS PROOF OF PURCHASE FOR WARRANTY VERIFICATION INCORRECT INSTALLATION OR GAS PRESSURE SETTINGS ARE NOT COVERED BY WARRANTY A SERVICE OR CALLOUT FEE WILL BE CHARGED IN THESE CIRCUMSTANCES. Regency Plateau™ PTO30 Outdoor Gas Fireplace...
  • Page 32 Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: __________________________________________________________ Regency, Regency Plateau are trademarks of FPI Fireplace Products International Ltd. Printed in Canada © Copyright 2015, FPI Fireplace Products International Ltd. All rights reserved.

This manual is also suitable for:

Plateau pto30-ulpg1Plateau pto30-lpg1

Table of Contents