Troubleshooting - Sharp IG-DC2A Operation Manual

TROUBLESHOOTING

The Plasmacluster Ion Generator
does not work.
The operation does not stop
although the engine of vehicle is
switched OFF
The product does not operate in
conjunction with engine
The operation is stopped
The Unit Replacing Light fl ashes
rapidly and the operation is
stopped
The Operation Lights "LOW"
and "HIGH" (blue) fl ash at the
same time and the operation is
stopped
IG-DC2A.EN.indd 15 IG-DC2A.EN.indd 15
Problem
Flashing rapidly (red)
Flashing (blue)
WHAT TO DO
Is a Car Adapter connected properly?
•
Please be connected defi nitely. (See E-5)
•
Does not a fuse blow?
Replace with a new fuse. (See E-12)
• If the main unit is operated even if the key of
the vehicle is pulled out or the engine switch
is turned OFF, pull out the cigar plug for
preventing the dead battery. (See E-7)
• With the vehicle that the power is supplied to
the cigar socket lighter even if the engine of
vehicle is switched OFF, the engine interlocking
function cannot be used.
• Press the Operation Button or the Turbo Button.
For preventing you from forgetting to turn them
OFF, the operation is automatically stopped in
8 hours after the operation is started.
• It is over the usage period of main unit. Replace
with new Plasmacluster Ion Generating Unit.
(See E-11)
• If the unit replacement period is exceeded, the
Unit Replacing Light (red) fl ashes rapidly and
the operation is stopped.
• The Plasmacluster Ion is not generated. Press
the Operation Button again and restart the
operation.
• Clean the electrode section of the
Plasmacluster Ion Generating Unit. (See E-9)
• Is the Plasmacluster Ion Generating Unit
installed correctly? Pull out the Plasmacluster
Ion Generating Unit and insert it to the end
again, and then press the Operation Button.
(See E-11)
If the light fl ashes repeatedly, contact the store
you purchased or SHARP authorized service
center.
E-13
2012/04/11 10:54:09 2012/04/11 10:54:09