Troubleshooting Table; Replacement Parts List - Lopi berkshire GS2 Owner's Manual

Maintenance

Troubleshooting Table

Problem:
Main Burners Will
Not Start
Heater Beeps
Thermostat Does
Not Work
Stove Will Not
Distribute Heat
Flames Are Too
Blue
Flames Are Too
Short (Under 6")
Comfort Control
Does not Work
Thin Layer of Soot
Covers the Glass
Accent Light Does
Not Work
Location of fuses (3 amp):

Replacement Parts List

Caution: Use only Travis Industries replacement parts. Do not use substitute materials.
Warning: Do not operate appliance with the glass front removed, cracked, or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Contact your local Travis Industries Dealer for a Replacement Parts List
© Travis Industries
Possible Cause:
The ON/OFF switch is turned to "OFF"
The remote control is not working correctly
The thermostat is disconnected or set too low
No Propane in Tank
The power backup batteries are dead
(heater will beep once repeatedly)
The heater encountered an error when trying to
start (heater beeps 3 times repeatedly)
The heater encountered a pilot error
(heater beeps 2 times repeatedly)
The ON/OFF switch is turned to "OFF"
The thermostat is set too low
The stove is not getting electricity
The stove is not up to temperature
The blower fuse may be blown
The stove has just been started
Improper air shutter adjustment
The flame height may be turned too low
The AA batteries may be dead
The logs or coals are placed incorrectly
Improper air shutter adjustment
The bulb may be burned out. ................................
The accent light fuse may be blown. .....................
(for qualified service personnel only)
Don't Call for Service Until You:
Turn the ON/OFF switch to "ON"
See the remote control instructions
See "Thermostat Operation"
Check Tank Level
Replace the batteries (see page 37)
Make sure gas is turned on. Turn heater off
for 5 seconds (make sure standing pilot is
off) – then turn back on.
Contact your dealer if this occurs.
Turn the ON/OFF switch to "ON"
Check thermostat
Check the breaker switch
Let the stove burn for at least 15 minutes
Replace the blower fuse. See fuse location
below.
This is normal - see "Starting the Stove for
the First Time"
Adjust Air Shutter - contact your dealer
Turn the flame height to "HI" -
See "Adjusting the Flame Height"
Replace the AA batteries (see page 37)
See "Log Set Installation"
Adjust Air Shutter - contact your dealer
See "Accent Light Replacement" on page 38
Replace the fuse. See fuse location below.
Light Fuse
4141208
39
Fan (Blower) Fuse
100-01399