US Shift 4R70W Installation And Operation Manual page 32

Save & Load:
Once you have created your calibration, you can save the file to your hard drive
or an external storage device. To save, click the Save
Then, browse to the location where you want it saved and click Save. Use
"Save As" under the FILE menu to leave the original file unchanged and create
a new version. Type the desired filename and click Save. Files are saved with a
.btc extension.
To load a calibration file, click the Open
to the file and click Open.
Writing a Calibration to the Quick 4:
For the changes you've made to take effect on the Quick 4 controller, you first
must write the calibration to the unit. Connect the
Quick 4 to your computer using a standard USB
cord (Type A to Type B). Click the Write
Calibration
menu will appear. If you aren't using multiple
calibrations, click the All Tables button to save
the calibration to the controller. The Quick 4 can
now be disconnected from the computer and
installed in the vehicle. (To use multiple tables,
you can create a new calibration and choose one of the other table buttons
when writing to the controller.) When the Quick 4 unit is disconnected from the
computer, the Write Calibration
32
button on the toolbar and a
button on the toolbar. Then, browse
button will be grayed out.
button on the toolbar.