US Shift 4R70W Installation And Operation Manual page 25

Ford Cruise Buttons without Cruise Module:
For this configuration, you will need to connect the Dark Blue wire (Pin 14 on the
Vehicle Connector) to the steering wheel buttons. (Follow the guidelines for
soldering found in the "General Installation" section.) The Light Blue wire is not
needed for this configuration. Remember that the Manutronic jumper must be
installed in the Quick 4 controller and the correct settings used in the Shiftware
setup. To enable the Manutronic, double-click the CRUISE OFF button. Press
ON or OFF once to disable it.
25