US Shift 4R70W Installation And Operation Manual page 24

Ford Cruise Buttons:
For this configuration, you will need to solder the Dark Blue wire (Pin 14 on the
Vehicle Connector) to the Blue / Black striped wire that connects the steering
wheel buttons to the cruise module. (Follow the guidelines for soldering found in
the "General Installation" section.) The Light Blue wire is not needed for this
configuration. The Manutronic jumper should not be installed in the Quick 4
controller. Be sure to use the correct settings in the Shiftware setup. To enable
the Manutronic, double-click the CRUISE OFF button. Press ON or OFF once to
disable it.
24