Twist Machine Shrifter
For this configuration, you will need to connect the Dark Blue wire (Pin 14 on the
Vehicle Connector) to COM2 of the receiver and connect the Light Blue wire
(Pin 6 on the Vehicle Connector) to COM1 of the receiver. You can use either a
momentary push-button on / off switch or a latching toggle on / off switch. (Refer
to the previous two sections on how to install and use the on / off switch.)
Remember that the Manutronic jumper must be installed in the Quick 4
controller and the correct settings used in the Shiftware setup.
28
TM
: