Momentary Shift Buttons with Latching On / Off Switch:
For this configuration, you will need to connect the Dark Blue wire (Pin 14 on the
Vehicle Connector) to your down-shift button (momentary) and connect the Light
Blue wire (Pin 6 on the Vehicle Connector) to your up-shift button (momentary).
To connect the on / off switch (latching), solder the switch's wire onto the Dark
Blue down-shift wire with a 680 Ohm resistor between them. (Follow the
guidelines for soldering found in the "General Installation" section.) Remember
that the Manutronic jumper must be installed in the Quick 4 controller and the
correct settings used in the Shiftware setup. Manutronic will be enabled when
the toggle switch is turned on and disabled when it is turned off.
26