Lacp Setting - HP nj2000 User Manual

LACP Setting

This page allows you to configure LACP for each port. The switch supports both static trunking and
dynamic Link Aggregation Control Protocol (LACP). LACP configured ports can automatically negotiate
a trunked link with LACP-configured ports on another device. You can configure any number of ports on
the switch as LACP, as long as they are not already configured as part of a static trunk. If ports on another
device are also configured as LACP, the switch and the other device will negotiate a trunk link between
them. If an LACP trunk consists of more than four ports, all other ports will be placed in a standby mode.
Should one link in the trunk fail, one of the standby ports will automatically be activated to replace it. The
LACP Table has one row for each port and three columns. The columns are:
Port - The front-panel port number.
LACP Enabled on Port - Allows LACP to be enabled or disabled. When the box is checked,
LACP is enabled.
Key Value (0..255, 0 means auto-generated key) - Used to determine the link aggregation
group membership, and to identify this device to other switches during negotiations.
Copyright © 2009 3Com Corporation. All Rights Reserved.
3Com Network Jack NJ2000
Page 23 of 44