Ip Address - HP nj2000 User Manual

I

IP Address

This page allows you to change the IP Address used by the switch.
DHCP Enabled - If enabled, the IP Address will be assigned from the DHCP server. If disabled, the IP
Address must be assigned manually.
Switch IP Address - The dot-separated IPv4 address used by the switch.
Subnet Mask - The dot-separated IPv4 Subnet address used by the switch. If in doubt, set this to be the
same as the Subnet Mask used by your PC.
Gateway IP Address - The dot-separated IPv4 Gateway address used by the switch. If in doubt, set this to
be the same as the Default Gateway address used by your PC.
Note: If DHCP is enabled, the word "Fallback" will be added to the front of the other parameter names to indicate
the usage of a manually assigned IP Address.
Note: If you change the IP address used by the switch you will lose contact with this Web Management-Interface
and may have to change the IP address on your PC to reconnect.
Note: It is extremely important that you do not forget the IP Address of the switch. If you forget the IP Address you
will have to manually reset the switch to its factory defaults. See the
cycle will not reset the IP Address.
There are three main buttons associated with this page:
HELP - Displays this window.
APPLY - Updates the switch configuration. No changes are made to the configuration until this button is
pressed.
CANCEL - All changes made to the page are discarded and the switch configuration remains unchanged
Copyright © 2009 3Com Corporation. All Rights Reserved.
3Com Network Jack NJ2000
Troubleshooting page for more details. Power
Page 10 of 44