Steps For Installation; Removing The Sunroof - Waeco coolair sp950 Installation Manual

CoolAir RT880, SP950
! CAUTION!
Improper installation of the air conditioning roof unit can result in irrepa-
rable damage to the device and put the safety of the user at risk.
The manufacturer will not be held liable for claims if the air conditioning
roof unit is not installed according to this installation manual. That applies
to malfunctions and the safety of the air conditioning roof unit, in particular
to injuries and damage to property.
I NOTE
After installing the unit, the specified parameters of the unit software must
be checked (chapter "Configuration of unit software" on page 43).
6.2

Steps for installation

NOTICE!
A
 The manufacturer only assumes liability for parts included in the scope
of delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
 Check whether the roof of the vehicle is able to support the weight of
a person before climbing onto it. Ask the vehicle manufacturer about
the permitted roof loads.
6.2.1

Removing the sunroof

➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
I NOTE
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
EN
Installation
39