Regular Maintenance; Drain Top (Waste) Tank; Drain Bottom (Clean Water) Tank; (Clean Water) Tank Filter - Numatic floorcare tt 1840 Troubleshooting Manual

Index page...

Drain Top (Waste) Tank

Use the drain hose to empty the top tank and flush the tank through with clean water, it is
advisable to let the tank air dry, by removing the separator, if leaving your machine for extended
periods of time.
1
Fitting Brush, Filling Machine, Water Tap, Raising the Floor Tool
Draining Top Tank, Draining Bottom Tank, Clean Water Filter

Regular Maintenance...

(Clean Water) Tank Filter...

2
*Note:- Machine side cut away for clarity.
Using Machine, Brush Overload, Battery Fuse
Clean Separator, Removing Top Tank
If you require further training or
assistance contact your supervisor

Drain Bottom (Clean Water) Tank

Located on the left of the machine is the yellow bottom tank drain cap.
Drain the clean water tank if leaving your machine for a extended period.
Note...
Do not over tighten the yellow drain cap, this can not only cause the
plastic to split, but make it extremely hard to remove the next time you want to
drain the tank. The cap has a rubber seal and might require a spanner to remove.
Located under the clean water inlet is the clean water filter.
Cleaning chemicals residue can cause the filter to become blocked causing
poor water flow.
Remove the clean water inlet (fig 1).
On the bottom of the tank is the clean water filter, clean the filter regularly
(fig 2).
Storage, Cleaning Floor tool and Inlet tube
Remove Bottom Tank, Re-assembling Machine Battery Care