Regular Maintenance; Tanks And Filters - Numatic TT 4045G Owner's Instructions Manual

!
The TT Range has been designed with ease of use in mind, this included easy
stripping-down and cleaning. After use, empty waste-water tank using emptying
hose and flush out with clean-water (Fig.20).
22
21
23
Remove the filter fitted into the separator and flush with clean-water (Fig.23) (Fig.24).
Placed into the top tank is grey filter basket, clean and flush with clean-water (Fig.25) (Fig.26).
27

Regular Maintenance

ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
Remove the two hoses to disconnect the separator from the machine
(Fig.21).
Lift off the separator. The separator has a sealing-rubber which should be
examined at every clean-down (Fig.22).
Rinse using clean-water.
24
The bottom (clean-water) tank is attached to the chassis and should only be
removed by a competent service engineer (Fig.27).
Clean by flushing with clean-water if required.
Excess water can be drained using the clear dump hose fitted to the rear of the
machine.
Located under the left hand side is a clean-water filter, ensure the clean water
tap is turned off before removing this filter (Fig.28).
Clean and flush with clean-water if required.
28
25
Fig.25
12
!
20
26
Fig.26