Operating The Mower; Controls; Before Mowing; Starting - Hayter Harrier 48 / 56 BBC Owner's Handbook Manual

OPERATING THE MOWER

Controls

Operate all control levers several times and ensure that
the cables move freely. Check that the engine stop and
ground drive clutch levers return freely to their rest
position when released. (Refer g.9)
IMPORTANT: To avoid damage to the cable the
Variable Speed Control should only be operated
whilst the engine is running.

Before Mowing

To prevent accidents, thoroughly inspect the area
and remove all objects which when contacted by the
mower cutterblade could become dangerous projec-
tiles. Inspect the area for hidden obstructions which
when contacted by the cutterblade could risk health
and safety or result in damage to the mower. Remem-
ber the location of these obstructions and ensure that
you mow around them. (Refer g.10)

Starting

Ensure that the fuel shutoff valve is in the 'ON' position
before attempting to start your mower for rst use.
(Refer g.11 - Code 493) or (Refer g.12 - Code 563)
Stand behind the mower, hold the handlebar together
and move the throttle to the fast position. With your
right hand hold the engine start - grip and pull slowly
Fig. 10
Fig. 9
until resistance is felt, release, then pull rapidly to crank
the engine. Carefully return the start grip to the storage
position when the engine starts. (Refer g.13)
If the engine does not start after 3 - 5 attempts - Refer to
"Trouble Shooting".
Note: The cutterblade is not engaged at this stage.
To prevent damage never pull the engine start grip
when the engine is running.
Engaging Cutterblade Drive
Always make sure the throttle stop lever is fully
forward.
1. Pull the blade stop lever back against the handlebar
and hold in position. (Refer g.14)
2. To engage the (BBC) cutterblade push the actuating
lever forward and down. (Refer g.14)
Fig. 11 Fig. 12
9
Fig. 13 Fig. 14
2
1