Hitachi Compute Blade 500 Series User Manual page 28

In the Detail information window, you can confirm the detail information of
switch module.
1 Touch Home > Hardware maintenance > Switch module > target
.
switch module > Detail information, and then the Detail information
window will be displayed.
Items
Install
Power
Status
LID
Maintenance Value: Maintenance mode is enabled. Value shows the time period, which
Type
Version
FRU
Sensor
2-14
Hitachi Compute Blade 500 Series LCD Touch Console User's Guide
Table 2-10 Switch module detail information
Displays the status of installed module.
Installed : Module installed
Not installed: No module installed.
Displays power status of module.
ON: Power-on
OFF: Power-off (including sleep status)
---: No module installed.
Displays a status of module operation.
Normal: Normal operation
Warning: Warning status
Fail: Failure status
---: No module installed.
Displays LID power-on/off status.
ON: Power-on LID
OFF: Power-off LID
---: No module installed.
is in minutes, until automatic cancellation.
OFF: Maintenance mode is disabled.
Displays the following various switches.
1G LANSW: Hitachi 1 Gb/sec LAN switch module (20 ports)
1G 40LAN-SW: Hitachi 1 Gb/sec LAN switch module (40 ports)
1/10G LAN-SW: Hitachi 1/10 Gb/sec LAN switch module
8G FC-SW: Brocade 8 Gb/sec Fibre Channel Switch Module
16G FC-SW: Brocade 16 Gb/sec Fibre Channel Switch Module
10G DCB-SW: Brocade 10 Gb/sec DCB Switch Module
1G LAN-PT: 1 Gb/sec LAN Pass-through Module
10G LAN-PT: 10 Gb/sec LAN Pass-through Module
---: No module installed.
Firmware
Original
Temperature
Voltage
Functional detail
Descriptions
Displays the firmware version in the module.
Some version may not be displayed.
Displays the Original FRU.
Displays the temperature.
Displays the s volt.