Hitachi Compute Blade 500 Series User Manual page 24

LID
Maintenance
Recovery wait
Power ON restriction
Logical Partitioning
1
N+M
Version
2-10
Hitachi Compute Blade 500 Series LCD Touch Console User's Guide
Items
Remaining time
IP address
Status
Last result
Server blade Current
firmware
Functional detail
Descriptions
Displays LID power-on/off status.
ON: Power-on LID
OFF: Power-off LID
-----: Indicates that there is no
information that should be displayed.
For example, when no server blade is
installed, or when the server blade is a
non-primary server blade.
Numerics: Shows that maintenance
mode is enabled, and displays the time
remaining until the maintenance mode
is over in minutes.
OFF: Shows that maintenance mode is
disabled.
The IP address for maintenance is
displayed when maintenance mode is
enabled. While the IP address is
displayed, the remote console cannot
be connected to the server blade.
Displays the time period until power-on
the server blade while recover time
configuration is enabled when power-
on the chassis.
Displays that power ON restriction is
enabled/disabled.
Power ON restriction may be set up if N
+M cold standby failover is failed.
Displays whether using or not using
LPAR manager.
Disabled: Not using LPAR manager
Enabled: Using LPAR manager
No Information: Infomation required
for N+M cold standby is not collected.
In Progress: Information required for N
+M cold standby is being collected.
Configured: Information required for N
+M cold standby is collected.
Not Configured: Infomation required
for N+M cold standby is not configured.
Displays the result of the last collection
or setting on N+M cold standby
infomation.
OK: It was successful.
NG: It failed.
Don't care: It is not started.
Displays the firmware version which is
currently operating.