Scanning Of Target Device - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

4.3. Scanning of Target Device

To scan the target device, select [Scan for Target Devices] in menu of Emulex OneConnect FCoE BIOS Utility
screen, and press <Enter> key.
Scanning of the target devices is performed, a list of the target devices is displayed as shown in the figure
below. In this screen, only the target device which is detected is displayed.
Make sure that WWN and LUN of the target storage is displayed correctly.
Copyright 2016 FUJITSU LIMITED
Figure 4-7
Figure 4-8
16 CA92344-0966-01