Configuring Fcoe Boot (Legacy Mode); Configuring Fcoe Boot In Legacy Bios - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

4. Configuring FCoE Boot (Legacy mode)

This chapter describes that procedure of configuring of FCoE Boot in Legacy BIOS.

4.1. Configuring FCoE Boot in Legacy BIOS

To configure FCoE Boot in Legacy BIOS, use BIOS utility.
During the server starts up, if the message "Press <Alt E> or <Ctrl E> to enter Emulex BIOS configuration utility"
as shown below is displayed, press <Alt E> key or <Ctrl E> key immediately(Less than 5 seconds).
List of adapters(controllers) which are mounted in the server is displayed as shown below, and then, select
subject adapter(controller), and press <Enter> key.
Copyright 2016 FUJITSU LIMITED
Figure 4-1
Figure 4-2
13 CA92344-0966-01