Configuring Fcoe Boot In Uefi; Startup Converged Network Adapter In Uefi Mode - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

Hide thumbs Also See for PRIMEQUEST 2000 Series:
Table of Contents

Advertisement

5. Configuring FCoE Boot in UEFI

This chapter describes that procedure of configuring of FCoE Boot in UEFI.

5.1. Startup Converged Network Adapter in UEFI mode

To install OS in UEFI mode, startup converged network adapter in UEFI mode.
During the server starts up, if screen as shown below is displayed, press <F1> key immediately.
Figure 5-1
Copyright 2016 FUJITSU LIMITED
26
CA92344-0966-01

Advertisement

Table of Contents
loading

Table of Contents