Fcoe Boot Configuration - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

1. FCoE Boot Configuration

To build an FCoE Boot Environment, you are required to configure the Converged Fabric Switch and the FCoE
Storage. This manual helps you understand for setup of Converged Fabric Switch and storage device.
In this setup, you should confirm WWN for CA ports of your target storage in FCoE Boot Environment.
We list basic components below which are required in constructing FCoE Boot environment of PRIMEQUEST
2000.
1) During FCoE Boot installation, keep out built-in disks from your server. After the installation, equip
those disks to your server.
You can add built-in disk to your server to reduce I/O load.
2) Download the latest version of driver and firmware of Converged Network Adapter from the following
URL and use them.
http://support.ts.fujitsu.com/download/Index.asp
Copyright 2016 FUJITSU LIMITED 6 CA92344-0966-01