4.1.2
PAIRING SCREEN
After the first application start or the device disconnection, the list with available heaters is displayed so
the user can simply select the heater to be controlled by means of the application. The selected heater
pairs with the mobile application by means of PIN code which is on the LED display of the boiler control
panel (see chapter Bluetooth). When the mobile application is paired with the heater, the pairing does not
need to be repeated until the user manually disconnects the connected device in the setting section
(specified in chapter 4.1.7 Setting section).
4.1.3
MODE SECTION
After pairing the thermostat with the mobile device, the width display in section 'Mode' is set as the home
screen, in case of height display it displays the signpost which can navigate to the section 'Mode'.
Identically to the real hater, turning the round controller enable setting the required mode (see Figure 11).
Turning the controller can be performed by finger turning on silver surface of the controller or by means of
the buttons with the arrow symbols. Individual modes can be set directly by clicking on the icons
symbolizing the respective modes. The upper right part displays the user set temperature. Water heating
in progress is signalled by pulsing centre of the displays controller in the application, identically to the real
heater.
Figure 10: Navigation panel
- 24 -