Ø10
Ø8
Figure 5
It is necessary to observe the below requirements during the electric wiring.
Heater is connected to power supply 1 PEN AC 230V/50Hz via a fixed movable
wire/wires (depending on the connection method).
The circuit must contain a breaker disconnecting all poles of the network, and a
circuit breaker (protector).
Installations in bathrooms, lavatories and showers must comply with the ČSN 33
2000-7-701 standard.
To adjust the distance from the wall, connect the wire of the external protective
bonding!
Respect the rules of protection against electrical injuries in accordance with ČSN 33
2000-4-41.
2.4.2 ELECTRONIC THERMOSTAT CONNECTION DIAGRAM
Ø8
Ø10
HEATING
UNIT
Figure 6
ANODE
- 13 -