Advertisement

Kozy-World
OWNER ' S OPERATION AND INSTALLATION MANUAL
GFN2815R
GFN2817R
GFN2819R
WA R N I N G
:
a d j us tm e n t, a l t e ra ti o n , s e rv i c e o r m a i n te na n c e
can cause injury or property damage. Refer to this
manual for correct installation and op eratio na l
procedures. For assistance or additional infor-
mation consult a qualified installer, service agency,
or gas supplier.
WARNING:
heater. It uses air (oxygen) f r o m
w h i c h i t i s installed. Provisions for adequate
combustion and ventilation air must b e p ro v i d e d .
R e f e r t o A i r F o r Combustion and Ventilation
section on page 5 of this manual.
World Marketing of America, Inc.
P. O. Box 192, Rt.. 22 West
Mill Creek, PA 17060
KOZY WORLD PHONE NUMBER :(814)643-1775
http://www.worldmkting.com
GFP2816R
GFP2818R
GFP2820R
I m p r o p e r
i n s t a l l a t i o n ,
This is an unvented gas-fired
t h e r o o m
R
WARNING
i n th is manu al i s no t fol l ow ed
exactly, a f i r e o r e xp l o si o n ma y
r e s u l t causing property d amage,
personal injury, or loss of life.
Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
l Do not try to light any appliance.
l Do not touch any electrical switch; do
not use any phone in your building.
l
Immediately
from a neighbor's phone. Follow the gas
supplier's instructions.
l If you cannot reach your gas supplier,
call the fire department.
Installation and service must be performed
by a qualified installer, service agency, or
the gas supplier.
This appliance may be installed in an
aftermarket*, permanently located, manu-
factured (mobile) home, where not pro-
hibited by local codes.
This appliance is only for use with the
type of gas indicated on the rating plate.
This appliance is not convertible for use
i n
with other gases.
WATER VAPOR: A BY-PRODUCT OF UNVENTED
ROOM HEATERS
Water vapor is a by-product of gas combustion.
An unvented room heater produces approximately
one (1) ounce (30ml) of water for every 1,000 BTU's
(.3KW's) of gas input per hour. Refer to page 4.
Consumer: Please retain these instructions for
future use.
Installer: Please leave these instructions with the
consumer.
*Aftermarket: Completion of sale, not for purpose of
resale, from the manufacturer.
1
V E N T - F R E E G A S
FIREPLACE SYSTEM
: If the information
call
your gas supplier
KW-BL035-03RHW-0505

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GFN2815R and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kozy-World GFN2815R

  • Page 1 Do not try to light any appliance. l Do not touch any electrical switch; do not use any phone in your building. Immediately call your gas supplier GFN2815R GFP2816R from a neighbor’s phone. Follow the gas supplier’s instructions. GFN2817R GFP2818R...
  • Page 2: Table Of Contents

    Table of Contents Safety Information Warnings........3 Air for Combustion and Ventilation......5 Installation...............7 Operating heater.............10 Cleaning&Maintenance...........13 Trouble Shooting............15 Specifications............16 Replacement ............17 Parts List..............18 Logs installation instruction........22 Mantel installation instructions........23 Assembling anchor..........28...
  • Page 3: Safety Information Warnings

    Propane/LP WARNING tial operation, slight smoking could gas leak. However, the odor added to Models GFN2815R, GFN2817R and occur due to log curing and heater Propane/LP gas can fade. Propane/ GFN2819R are equipped for Natural burning manufacturing residues.
  • Page 4: Safety Information

    SAFETY INFORMATION LOCAL CODES UNPACKING Continued ln stall and use h eater with care. 1. Remove top inner pack. 15. Turn off and unplug heater and let F o l l o w a l l l o c a l c o d e s . I n t h e 2.
  • Page 5: Air For Combustion And Ventilation

    AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING : This heater The air that leaks around doors and The National Fuel Gas Code, ANSI shall not be installed in a confined windows may provide enough fresh Z223.1 defines a confined space as a space or unusually tight construc- space whose volume is less than 50...
  • Page 6 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater 26,000 Btu/Hr Vented gas heater Btu/Hr Total 56,000 Btu/Hr Gas heater logs Btu/Hr Other gas appliances* + Btu/Hr...
  • Page 7: Installation

    INSTALLATION NOTICE: This heater is intended for use as supplemen- tal heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, you run system's circulating blower while using heater.
  • Page 8: Connecting To Gas Supply

    INSTALLATION Continued CONNECTING TO GAS The installer must supply an external IMPORTANT: Inst all equ ipment SUPPLY regulator. The external regulator will shutoff valve in an accessible location. reduce incoming gas pressure. You The equipment shutoff valve is for WARNING: A qualified service must reduce incoming gas pressure turning on or shutting off the gas to person must connect heater to gas...
  • Page 9 INSTALLATION Continued CHECKING GAS CONNECTIONS WARNING: Test all gas piping CAUTION: Make sure external WARNING: Never use an open and connections for leaks after regulator has been installed be- flame to check for a leak. Apply a installing or servicing. Correct all tween gas supply and heater.
  • Page 10: Operating Heater

    INSTALLATION WHAT TO DO IF YOU SMELL GAS LIGHTING INSTRUCTIONS SEE WARNING in Page 1 for proper Continued Note: If operating by transmitter, you instructions. must set the control knob on ELECTRIC Use only your hand to push in position. Do not set the control knob INSTALLING LOGS control knob.
  • Page 11 OPERATING HEATER (Note: on the auto select of main burner, the main burner does not Continued respond immediately to the set temperature until about one minute later.) manual select of main burner: Press BURNER button, the flame is on “MAN” select. At this selection, Fig 15 - Control board the main burner will keep working no...
  • Page 12 nTO TURN OFFn nOPERATIONS OFn LIGHTING GAS TO APPLIANCE INSTRUCTIONS TURN-OFF Shutting Off Heater If power is off, you can operate the 1. Manual turn-off: when the heater is Turn control knob clockwise to the fireplace by manual in operation, press the ING/OFF but- OFF position.
  • Page 13: Cleaning&Maintenance

    OPERATING HEATER Continued INSPECTING BURNERS BURNER FLAME PATTERN CLEANING AND MAINTENANCE Figure 19 shows a correct burner C h e c k p i l o t f l a m e p a t t e r n a n d WARNING: Disconnect power be- flame pattern.
  • Page 14: Cleaning And Maintenance

    CLEANING AND MAINTENANCE Continued CABINET Clean the pilot assembly also. A yellow C A U T IO N : Yo u m u st k eep Air Passageways tip on the pilot flame indicates dust and c o n t r o l a r e a s , b u r n e r , a n d Use a vacuum cleaner or pressur- dirt in the pilot assembly.
  • Page 15: Troubleshooting

    TROUBLESHOOTING NOTE: BEFORE YOU SWITCH TO “ELECTRIC” CONTROL LEVEL FROM MANUAL CONTROL, YOU NEED TO TURN THE KNOB TO “OFF” LEVEL FIRST AND WAIT FOR ONE MINUTE, THEN TURN THE KNOB TO “ELECTRIC”. IN CASE OF “ELECTRONIC” CONTROL LEVEL DOES NOT WORK, PLEASE TURN THE CON- TROL KNOB COUNTERCLOCKWISE TO “OFF”...
  • Page 16: Specifications

    1. Metal expanding while heating or noise just after burner is lit or If noise is excessive, contact quali- contracting while cooling shut off fied service person SPECIFICATIONS GFP2816R GFN2815R GFP2818R GFN2817R GFP2820R GFN2819R Btu(Variable) Gas Type LP Gas Natural Gas...
  • Page 17: Replacement

    If they can't supply original rep lac em en t p art(s), call KO ZY- W ORLD ’s toll free number at (814) 643-1775 for referral information. When calling KOZY-WORLD or your dealer, have ready: Your name Your address...
  • Page 18 ILLUSTRATED PARTS BREAKDOWN GFN2815R GFP2816R GFN2817R GFP2818R GFN2819R GFP2820R...
  • Page 19: Parts List

    PARTS LIST This list contains replaceable parts used in your heater. When ordering GFN2815R parts, follow the instructions listed under Replacement Parts on page 17 of this manual. GFP2816R GFN2817R GFP2818R GFN2819R GFP2820R...
  • Page 20 ILLUSTRATED PARTS BREAKDOWN GFN2815R GFP2816R GFN2817R GFP2818R GFN2819R GFP2820R...
  • Page 21 This list contains replaceable parts used in your heater. When ordering GFN2815R parts, follow the instructions listed under Replacement Parts on page 17 of this manual. GFP2816R GFN2815R GFP2816R refer to ‘W” column GFN2817R GFN2817R GFP2818R refer to “C” column GFP2818R GFN2819R GFP2820R refer to “O” column...
  • Page 22: Logs Installation Instruction

    LOGS INSTALLATION INSTRUCTIONS STEP 1: Install the log 1 on the angle iron. 1. All logs. See FIG (1). See FIG (2). FIG (1) FIG (2) STEP 3: Install the log 3 on the front angle. STEP 2: Install the log 2 on the right rear See FIG (4).
  • Page 23: Mantel Installation Instructions

    Mantel Installation Instructions...
  • Page 24 Assemble the Base 1. Set top base panel on the ground, with the surface marked 1 upward. Set connectors in four screwed holes in the top base panel (Note: Be sure to fasten the connectors tightly) - See FIG (a). Connector FIG (a) 2.
  • Page 25 4. Set top base panel on the ground, with the surface marked 1 upward. Set connectors in seven screwed holes in the top base panel (Note: Be sure to fasten the connectors tightly), See FIG (f). Connector FIG (f) 5. Piece together the assembled structure and front base panel marked 4. Note: Insert the connectors on the front base panel in the seven corresponding holes of assembled struc- ture-see FIG (g).
  • Page 26 Installation Instructions of Mantel and Fireplace Note: The fireplace is quite big and heavy. For your safety, at least two people are needed to install the fireplace to avert tilting. Install fireplace in the desired position. Install two brackets at the fixed place with six 5×35 self-tapping screws and anchors as shown in FIG (1), assembling the anchors see page 28.Tear the dust-proof plastic film off regulator.
  • Page 27 FIG (2) Install base Push base to mantel and ensure the rear part of the base fits with the col- umn face closely, see FIG (3). FIG (3)
  • Page 28: Assembling Anchor

    ASSEMBLING ANCHOR 1. To ensure the assembling position of anchor per FIG (1), use the hole of anchor to mark the position of screw on the wall and then move the anchor away. Attaching to Wall Stud Method For attaching bracket to wall studs a.

This manual is also suitable for:

Gfp2816rGfn2817rGfp2818rGfn2819rGfp2820r

Table of Contents