Advertisement
I N S T A L L A T I O N
Before commencing with the installation it is important that these instructions are read and fully understood.
The DOVRE 700CBW is a specially designed stove for burning wood only and has been tested and approved by the U.S. Environmental
Protection Agency (EPA) in accordance with their stringent woodstove emission limits. It is essential that the wood used is well seasoned (min 2
years) and has a maximum moisture content of 20%. If unseasoned wood is used, heat outputs will not be obtained and serious damage will
occur in the chimney and flueways. The DOVRE 700CBW incorporates a high technology combustion system to provide high efficiencies and
low atmospheric pollution
The dimensions of your new stove are illustrated in fig 1. Be
careful to ensure that your fireplace is going to accept the
appliance and that you have allowed for 30cms of hearth
space in front of the stove.
R E G U L A T I O N S
CHECK THAT YOUR INSTALLATION WILL BE IN
COMPLIANCE
WITH
CURRENT
BUILDING
REGULATIONS.
A S S E M B LY
As the Dovre 700CBW is constructed from heavy cast iron, it
is advisable for two people to assemble and position the
appliance.
1
1. Open the stove door and remove all loose parts within.
2
2. To assist with lifting, remove the side panels by lifting
and disengaging from the bottom and top pins. see fig 2.
3
3. Carefully lift the appliance from the wood pallet, taking
care not to slide or tilt the unit, and place in position on the
hearth.
4. Refit the side panels by firstly engaging in the top pins
4
and then positioning on the bottom pins.
5
5. For a top flue connection, attach the circular cast iron
collar to the aperture located at the top of the appliance,
using the nuts, bolts and washers supplied. Use a small
amount of fire cement to ensure an air tight seal before fixing.
For a rear flue connection, adopt the same procedure using
the rear aperture. Fit the cast iron circular cover plate to the
unused aperture again using a small amount of fire cement as
a seal. The cover plate is attached using the fixing bar and
nuts and bolts supplied. refer to fig 3.
6
Fit the front ash lip using the two 8mm x 30mm hex
headed bolts supplied. see fig 4.
I N S T R U C T I O N S
7 0 0 C B W
150
FIG1
FIG2
FIG3
1
DOVRE 10 YEAR WARRANTY
If the castings on this appliance should prove to be defective within ten years of the purchase date,
the faulty castings will be replaced free of charge, subject to the following conditions.
1. The purchaser shall complete the registration section below and return it within seven
days of purchase. Failure to return the registration could result in delays in processing any
claims.
2. The appliance shall have been installed in compliance with the installation instructions.
3. The appliance shall not have been used for the burning of unseasoned wood.
4. This warranty only applies to the appliance body castings and does not include renewable
components including grates, ashpans, glass, seals and baffle plates.
5. This warranty does not cover site visits and any claims should be notified to your dealer.
This warranty does not affect the Statutory Rights of Consumer Purchasers.
Please complete and return this section within seven days of purchase to:
Dovre Castings Ltd, Weston Works, Weston Lane, Tyseley, Birmingham B11 3RP.
NAME:
ADDRESS:
TELEPHONE NUMBER:
MODEL:
DATE OF PURCHASE:
DEALER:
Advertisement
