Save this booklet and pass to any subsequent user who can also profit by it. Introduction Your DOVRE purchase has made you the owner of a high quality product that sy m - bolizes a new generation of energy -saving and ecologically safe heaters, producing convection heat as well as radiant heat with optimum efficiency.
Installation guideline 3.1. Preparatory measures The stove should be hermetically connected to a well-functioning chimney, suffi- ciently enclosed to keep combustible materials (floor and walls) at a distance, and should be installed in a room with sufficient ventilation. Please inform about national or local norms and regulations concerning this subject. Your distributor will give y ou the necessary advice.
way that wind will not hinder, but promote the smoke flow. • Especially if the flue runs through unheated rooms or outside the house, further insulation is necessary. Metal chimneys or parts of the chimney outside heated rooms should always have double -walled, insulated flues. The part of the chim - ney outside the roof should always be insulated.
3.2. Preparing the stove Please inspect the stove for damage caused during transport immediately after deliv- ery and notify your distributor in case there are any defects. Do not put the stove into operation in the meantime. In order to avoid damaging the stove during installation and to make handling of the stove easier, it is recommended to remove previously all loose parts (fire-resistant bricks, ashtray, ...) from the stove.
3.2.2. Assembling the “cold handle” Assemble the different parts of the handle, i.e. a screw M8x50, a wooden handle and a nut, as indicated on the sketch. 3.3. Finishing When the stove is placed in the final position and hermeti- cally connected to the chimney, you can replace all of the loose parts.
4.2. Air supply adjustment For the supply of combustion air, the stove is equipped with three vents at the rear, of which two are adjustable by means of two levers at the bottom of the front panel of the stove (see picture). Through special air ducts, primary air (1) is led to the bot- tom of the combustion chamber and passes through the ash removal port.
Add extra fuel when necessary. Never add too much fuel. It is best to fill the stove for one third and to top it up on a regular basis. Always open the filling door slowly and for a short space at a time. Before filling up, the charcoal bed should be carefully spread open.
Open the port (see picture) and sweep the redundant ashes into the ashtray by means of the scraper. With the "cold handle", you can pull the ashtray from the stove (see picture). Relatively speaking, burning wood produces little ash and it will not be necessary to remove it each time daily.
Notified body: 1641 Wij, Nous, Wir, Dovre nv Nijverheidsstraat 18 B2381 Weelde verklaren bij deze dat de kachel 640CB, 760CB conform is volgens de EN 13240. déclarons que le poële 640CB, 760CB est conforme au norme EN 13240. declare that the oefen 640CB, 760CB is in conformity with the EN 13240.