Waeco CoolFreeze CFX28 Operating Manual page 30

Safety instructions
 Only connect the device as follows:
– With the DC cable to a DC plug socket in the vehicle (e. g.
cigarette lighter)
– Or with the 230 V connection cable to the 230 V AC mains
supply
 Never pull the plug out of the socket by the cable.
 If the cooler is connected to the DC socket: Disconnect the
cooler and other power consuming devices from the battery
before connecting the quick charging device.
 If the cooler is connected to the DC socket: Disconnect the
cooler or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
 The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
 The cooling device contains inflammable cyclopentane in the
insulation. The gases in the insulation material require special
disposal procedures. Deliver the device at the end of its life-
cycle to an appropriate recycling.
2.2 Operating the device safely
CAUTION!
!
 Before starting the device, ensure that the power supply line
and the plug are dry.
NOTICE!
A
 Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
 Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
 Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other
objects so that the air can circulate.
 Ensure that the ventilation openings are not covered.
 Do not fill the inner container with ice or fluid.
 Never immerse the device in water.
 Protect the device and the cable against heat and moisture.
30
CFX28 – CFX65DZ
EN