Table of Contents
Advertisement
3
Disconnect the cables connected to the device (1)(2). Slide the tool-
less bracket to the left (3) and pull out the device from the drive bay(4).
Upgrading the processor
This section explains the procedures for removing and installing the
processor and heat sink fan (HSF) assembly.
Processor configuration guidelines
The mainboard supports Intel
processors.
Observe the following guidelines when replacing or installing a processor.
•
The CPU socket must always be populated. If no processor is installed
in this socket, the system will fail to boot.
•
Before removing the processor, make sure to back up all important
system files.
•
Handle the processor and the HSF assembly carefully. Damage to
either may prevent the system from functioning properly.
Note: A long-nosed screwdriver is needed to remove/install the HSF
assembly
®
Xeon™ 3000 Sequence and Pentium
.
29
Advertisement
Table of Contents
Troubleshooting
