Wiring Up The Console; Set-Up And Test; Technical Documentation - AudioArts Engineering R-5 Owner's Manual

R-5 / Aug 00
R-5 / Jan 97

WIRING UP THE CONSOLE

With the console mainframe installed and properly grounded, and the
rackmount power supply installed, connected, and console power-up
verified, you are now ready to proceed with audio and control wiring.
Note the main portion of this manual is organized by channel type
(inputs, outputs, monitors and accessories). Each chapter has a special
section devoted to wiring hook-ups; use the information in these sections
(typically called "Audio Connections" and "Logic and Control Wiring") to
proceed.
Specific Wiring Instructions:
Mono Mic Inputs ......................................................... 2-4
Stereo Line Inputs ...................................................... 3-4
Telephone Input ......................................................... 4-4
Outputs ....................................................................... 5-4
Monitors ..................................................................... 6-5
Accessories ................................................................ 7-4

SET-UP AND TEST

Once all wiring is complete, as called out in the instructions listed above,
proceed to Chapter 8 ("Set-up and Test") which will walk you through a
check-out procedure for your R-5 console.

TECHNICAL DOCUMENTATION

Technical documentation and drawings (schematics, printed circuit
board pictorials and load sheets, parts lists) are contained in Chapter 9.
F S / B I
IRST TEPS ASIC NFO
Page
Page 1 - 9