Louver Control - Fujitsu AS*G09LTCB Service Instructions Manual

7. LOUVER CONTROL

1. VERTICAL LOUVER CONTROL
(Function Range)
Each time the button is pressed, the air direction range will change as follow:
Types of Air flow Direction Setting:
, , : During Cooling/Dry modes
, , , : During Heating
The Remote Controller's display does not change.
Use the air direction adjustments within the ranges shown above.
The vertical airflow direction is set automatically as shown, in accordance with the type of operation selected.
Cooling / Dry mode
Heating mode
During AUTO mode operation, for the first a few minutes after beginning operation,
air-flow will be horizontal 1; the air direction cannot be adjusted during this period.
The air flow direction setting will temporarily become 1 when the temperature of the air -flow is
low at the start of the Heating mode.
2. ADJUST THE RIGHT-LEFT LOUVERS
Move the Right-Left louvers to adjust air flow in the direction you prefer.
2. SWING OPERATION
To select Vertical Airflow Swing Operation
When the swing signal is received from the remote controller, the vertical louver starts to swing.
(Table10 : Swinging Range)
Cooling / Dry mode
Fan mode ( )
The SWING operation may stop temporarily when the air conditioner's fan is not operating,
or when operating at very low speeds.
To select Horizontal Airflow Swing Operation
(No function)
Horizontal flow
Downward flow
Range
01-07
Knob (2 places)
Fig.9 : Air Direction Range
1
2
3
4
5
6
7
Right-Left Louvers
Knob