3. Disassembly and Reassembly
3-9 Removing Heater-Bake
Parts
Heater-Bake
* Reassembly of All part is the reverse order of disassembly.
Explanation Photo
Explanation
1.
Unplug range or disconnect power.
2.
Pull the range out of its mounting location so that
you can access the rear of the unit.
3.
Remove Cover-Back Main Wire.
4.
Remove Terminal-Block and Bracket-Cover
Access(with Adiabatic-Terminal) by unscrew 3
points.
5.
Remove Cover-Warming Heater and disconnect 2
wires.
6.
Remove the duct by unscrew 4 points.
7.
Unscrew 2 points of Heater-Bake.
8.
Cut the Adiabatic-Rear based on the lower side.
9.
Carefully pull out Heater-Bake and replace it.
23