3. Disassembly and Reassembly
3-8 Removing Heater-Bake
Parts
Heater-Bake
* Reassembly of All part is the reverse order of disassembly.
Explanation Photo
Explanation
1.
Unplug range or disconnect power.
2.
Pull the range out of its mounting location so that
you can access the rear of the unit.
3.
Remove Cover-Back Main Wire.
(See step 3~4 on page 10 for procedure)
4.
Remove Terminal-Block and Bracket-Cover
Access(with Adiabatic-Terminal) by unscrew
3 points.
5.
Disconnect the two wires from the warming drawer
heating element.
6.
Remove the duct By unscrew 4 points.
7.
Remove the two screws securing the Heater-Bake.
8.
Cut the insulation on the lower side.
9.
Carefully pull out Heater-Bake and replace it.
16