Grandstream Networks GXP-2000 User Manual page 40

Grandstream Networks, Inc.
GXP-2000 User Manual
6
Firmware Upgrade
6.1 Upgrade through HTTP
To upgrade software, GXP-2000 can be configured with an HTTP server where the new
code image file is located. For example, following URL in the HTTP Upgrade Server:
http://firmware.mycompany.com:6688/Grandstream/1.0.0.4
Where firmware.mycompany.com is the FQDN of the HTTP server,":6688" is the TCP
port the HTTP server listening to, "/Grandstream/1.0.0.4" is the RELATIVE directory
to the root dir in HTTP server. Thus, you can put different firmware into different
directory as well.
Note: To enable HTTP firmware upgrade, "Auto Upgrade" field has to be set to Yes.
In addition, the device will check the HTTP server in the number of days that is defined
in "Check for new firmware every" field.
6.2 Upgrade through TFTP
To upgrade software, GXP-2000 can be configured with a TFTP server where the new
code image is located. The TFTP upgrade can work in either static IP or DHCP mode
using private or public IP address. It is recommended to set the TFTP server address in
either a public IP address or on the same LAN with the GXP-2000.
There are two ways to set up the TFTP server to upgrade the firmware, namely through
voice menu prompt or via the GXP-2000's Web configuration interface. To configure
the TFTP server via voice prompt, follow section 5.1 with option 06, once set up the
TFTP IP address, power cycle the device, the firmware will be fetched once the device
boots up.
To configure the TFTP server via the Web configuration interface, open up your
browser to point at the IP address of the GXP-2000. Input the admin password to enter
the configuration screen. From there, enter the TFTP server address in the designated
field towards the bottom of the configuration screen.
Once the TFTP server is configured, power cycle the GXP-2000.
- 41 -