Grandstream Networks GXP-2000 User Manual page 36

GXP-2000 User Manual
Auto Upgrade
Voice Mail User
ID
Subscribe for
MWI:
Auto Answer
Offhook
Auto-Dial
Enable Call
Features
Disable Call
Waiting
Send DTMF
DTMF Payload
Type
Send Flash
Event
NTP server
When set toYes, device will do HTTP upgrade and provisioning.
In "Check for new firmware every" field, enter the number of days to
enable GXP-2000 to check the HTTP server for firmware upgrade or
configuration in the defined period of days.
When set to No, GXP-2000 will only do HTTP download at boot up.
When configured, user will be able to dial voice mail server by
pressing "MSG" button.
Default is NO. When set to "Yes" a SUBSCRIBE for Message
Waiting Indication will be sent periodically.
When configured to Yes, the device will automatically switch to
speaker when this is a incoming call
This parameter allows users to configure a User ID or extension
number to be automatically dialed upon offhook. Please note that only
the user part of a SIP address needs to be entered here. The GXP-
2000 will automatically append the "@" and the host portion of the
corresponding SIP address.
Default is No. If set to Yes, Call Forwarding & Do-Not-Disturb are
supported locally
Default is No.
This parameter controls how DTMF events are transmitted. There are
3 ways: in audio which means DTMF is combined in audio signal
(not very reliable with low-bit-rate codec), via RTP (RFC2833), or
via SIP INFO.
This parameter sets the payload type for DTMF using RFC2833
This parameter allows users to control whether to send an SIP
NOTIFY message indicating the Flash event, or just to switch to the
voice channel when users press the Flash key.
This parameter defines the URI or IP address of the NTP server which
is used by the GXP-2000 to display the current date/time.
- 37 -
Grandstream Networks, Inc.