Model Reset; Trainer Mode; Student Mode - Fly Sky FS-T6 Instruction Manual

Digital propotional radio control system
15.05.

Model reset

This function will reset the currently selected mode to
its default. The other models will not be affected. This
can be useful when a setup is going nowhere and
needs a fresh start. Since this function is destructive,
a confirmation will be asked.
15.06.

Trainer mode

This function allows you to connect 2 transmitters together
using a dedicated cable connected to the back interface.
One is the instructor (the master) and the other is the
student (the slave). Once enabled, switching on the
selected trainer switch will set up the remote as the
instructor and use the trainer transmitter to control the
model. As soon as the trainer switch is turned off, the
student transmitter regains control. To be effective, the 2
transmitters have to use the same radio mode (see below).
15.07.

Student mode

This function works together with the trainer mode. Once
enabled, all mode settings are bypassed and the sticks
position is sent directly to the instructor's transmitter. At
that time, the student transmitter must not control any
model directly and any receiver bound to the trainer
transmitter must be turned off. Bypassing all student
settings allows both student and instructor to share the
instructor settings to avoid any glitch when switching
between the student and its instructor.
模型重设
此功能将当前所选择的模型数据恢复到默认值，其他的
l
模型的数据不会被修改。设置调乱时可使用该功能进行初始
化设置。当前所选择模型的数据将被永久删除，并且无法恢
复，因此会有一个询问提示， 再次确认是否执行该操作。
教练模式
此功能允许用户通过教练线连接两台发射机一同控制。
一台发射机为教练控制，一台发射机为学员控制。一旦开启
此功能，教练开关打开时，教练可通过自己的发射机控制模
型。当教练开关关闭时，学员恢复控制权。
学员模式
此功能和教练功能一同使用。一旦开启此功能， 学员机
上所有数据都被锁定，操纵杆的数据直接由教练机定义。而
且学员发射机一定不能直接控制任何模型，任何与教练发射
机对上码的接收机必须关闭。学员机上所有的设置数据将被
锁定，教练机和学员机共享教练机上的设置数据防止教练开
关打开时教练机和学员机的脉冲干扰。
FS-T6
14